Publicité
Les langues disponibles
Les langues disponibles
UNPACKING
1. Remove heater from carton.
2. Remove all protective packaging applied to heater
for shipment.
3. Check heater for any shipping damage. If any
damage is found immediately contact the
manufacturer at 866-740-2497.
CAUTION: DAMAGED PARTS MAY
COMPROMISE SAFE OPERATION.
• DO NOT INSTALL INCOMPLETE COMPONENTS.
• DO NOT INSTALL SUBSTITUTE COMPONENTS.
• DO NOT INSTALL DAMAGED COMPONENTS.
4. Some components are packaged unattached from
the stove in order to ensure their safety during
shipping. Please find the protective packaging, likely
inside the stove door, to proceed with assembly.
ASSEMBLY
STEP 1 - Display Panel
Insert the display panel into the top and rear of the
stove. Be sure that the display panel screen is facing
towards the front of the stove. Secure the screen using
two of the provided screws.
STEP 2 - Display Panel Power Cord
This cord should be wrapped up near the top of the
stove. Insert free end into the back of the display
panel (see figure 16 on page 15). This wire should
already be connected to the stove's power board. This
connection can be checked behind the access plate at
the bottom and rear of stove.
STEP 3 - Main Power Cord
The main power cord attaches to the stove at the
exposed socket in the rear of the stove. Once any
necessary assembly of the display panel screen is
complete, you may briefly plug your stove in and press
red power button to ON to make sure that it functions
properly before proceeding with installation. Turn OFF
and unplug the stove once you confirm that the display
panel works.
CAUTION: DO NOT LEAVE THE STOVE
PLUGGED INTO ANY ELECTRICAL SUPPLY
DURING ASSEMBLY OR INSTALLATION.
STEP 4 - Firepot
With the stove unplugged from any power supply, the
firepot should be inserted into the stove so that it is
securely positioned and also the hot surface igniter
should be able to make physical contact with pellets
that would be held in the firepot. See Figure 2 or 3.
Grand Teton Wood Pellet Fire Stove
Figure 2
N60WTS and
N130WTS firepot
A cleaning tool is also packaged which facilitates safely
cleaning the firepot perforations of debris.
STEP 5 - Air Intake Kit
Locate the air intake kit packaged with the stove.
See Figure 4. Take measurements of your space and
plan for the installation of horizontal venting to the
outside as may be required per recommendations in
"FRESH AIR AND VENTILATION REQUIREMENTS 1" on
page 8. Follow all ventilation requirements and
guidelines specified in "INSTALLATION" on page 8.
Termination Cap
Figure 4
Intake Kit
Additional Assembly N60WTS, N130WTS
• The door handle: open the door, and screw the
plastic grip onto the thread of the
Figure 5
Door Handle
7
Operating Instructions and Owner's Manual
41
Figure 3
NBF66WTS
firepot
Hose Clamp
2" Flex Hose
handle.
Publicité
