Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING CONTINUED
SYMPTOM
Too much fuel in the
firepot. The fuel can not be
completely and thoroughly
burned.
Not enough fuel in the
firepot.
After the fire has started, the
stove turns off 15 minutes
later.
Orange flame, pellets piling
up in firepot,carbon residue
forming on glass.
Grand Teton Wood Pellet Fire Stove
CAUSE
The feeding speed
1. Increase the fan's speed to increase the rate of
is faster than what
combustion can
support.
The feeding speed
1. Decrease the fan's speed to decrease the rate of
is too low to
support the rate of
combustion.
The pellet hopper is
low on fuel.
1. Unplug the unit so that it will not start suddenly
The auger is not
2. Check that the auger is not blocked. If it is
operating.
3. Check that the auger screw fastening the auger to
The 30
C
1. Check that wires to the switch are sufficiently
o
temperature switch
has triggered.
2. Replace the 30
The pressure switch
inside the stove is
broken.
1. Check that the air inlet vent in the front is open.
2. Check that the door and window gaskets are
Insufficient air
3. Check if the air inlet ducting and the combustion
for sufficient
combustion.
4. Increase the cross sectional area of the ducting.
5. Increase the fan's speed to increase the rate of
6. Contact the manufacturer for assistance.
24
SOLUTION
combustion.
combustion.
Check that the pellet hopper has a sufficient
amount of fuel.
and then unblock the auger.
blocked, remove the cause of the jamming.
the motor is secure.
connected.
C temperature switch.
o
Replace the pressure switch.
intact.
exhaust ducting are blocked.
combustion.
Operating Instructions and Owner's Manual
Publicité
