Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
This wood heater needs periodic inspection and repair
for proper operation. It is against federal regulations
to operate this wood heater in a manner inconsistent
with operating instructions in this manual.
CAUTION: TURN OFF AND UNPLUG THE
STOVE FROM ANY SOURCE OF ELECTRICAL
POWER TO UNIT BEFORE PERFORMING ANY
MAINTENANCE OR SERVICE OPERATIONS.
CAUTION: ALLOW STOVE TO COOL DOWN
BEFORE PERFORMING ANY MAINTENANCE
OR SERVICE OPERATIONS.
CAUTION: DURING ANY ASSEMBLY OR
DISASSEMBLY, BE WARY TO NOT DROP ANY
ITEMS (SCREWS, ETC.) INTO THE PELLET
HOPPER. DEBRIS CAN JAM THE AUGER AND
DAMAGE THE STOVE.
The frequency which your stove's requires cleaning
and maintenance depends on the fuel that you use.
High moisture, ash, dust, and chips can more than
double the necessary maintenance. Use only the tested
and recommended wooden pellets fuel.
Clean the fire pot and fire pan every day, before using
the stove and while the stove is cooled down, the
stove is unplugged, and there are no embers. Use a
vacuum cleaner to remove ash and debris from the fire
pot, and then lift the fire pot to also clean the fire pan.
It is important that ash or debris does not block any air
openings.
A general cleaning schedule is as follows:
• Fire Pot: After 10 bags of wood pellets, or every
day. Whichever is more frequent.
• Ash Drawer: After 50 bags of wood pellets
• Passageways: After 100 bags of wood pellets
• Blower: After 100 bags of wood pellets
CLEANING: FIRE POT & PAN
CAUTION: IF STOVE IS INTENDED TO
OPERATE CONTINUOUSLY, IT MUST BE
TURNED OFF TWICE WITHIN EACH 24 HOUR
PERIOD IN ORDER TO CLEAN THE FIRE POT
AND FIRE PAN. ALWAYS ALLOW THE STOVE
TO COOL DOWN AND ANY EMBERS TO
EXTINGUISH BEFORE CLEANING THE FIRE
POT AND FIRE PAN.
Make sure that you put the fire pot back onto the fire
pan in the correct orientation, so that pellets can be
added to the pot and successfully ignited for the next
operation of the stove.
Grand Teton Wood Pellet Fire Stove
CLEANING: GLASS
WARNING: DO NOT CLEAN GLASS WHEN
HOT.
Though the circulation of air across the glass reduces
acidic ash build up, cleaning the glass in the stove
door is still required periodically. Cleaning is necessary
to prevent glass from being weakened which may
increase likelihood of cracks. It is not acceptable to
operate the stove with cracked or broken glass.
The best way to clean the door glass is using a damp
cloth that has a smear of cool ash on it. For extra
stubborn dirt, consult your local hardware store or
stove specialist for a suitable cleaner.
WARNING: DO NOT CLEAN GLASS WITH
ABRASIVE CLEANERS OR BY ANY OTHER
PROCESS WHICH MAY SCRATCH OR
DAMAGE THE GLASS.
CLEANING: OUTLET PASSAGEWAY
The outlet passageway should be cleaned at least once
a year. Burning high ash pellets may require that the
passageway are cleaned more frequently.
Figure 20
Outlet Duct
18
Operating Instructions and Owner's Manual
Publicité
