Grundig CMS 5000 Mode D'emploi page 33

SYSTEM­SETTINGS­
PBC­Wlan­setup:
Push Button Configuration, it is to connect the AP
that supports WPS (Wi-Fi Protected Setup).
View­settings:
View the information of current connected net-
work: Active connection, MAC address, Wlan
region, DHCP, SSID, IP address, Subnet mask,
Gateway address, Primary DNS and Secondary
DNS.
Manual­settings:
Enable or disable DHCP (Dynamic Host
Configuration Protocol). Input the SSID, WEP /
WPA key and/or other configuration.
Network­profile:
The device remembers the last four wireless net-
works it has connected to, and automatically tries
to connect to whichever one of them it can find.
From here you can see the list of registered net-
works. You can delete unwanted networks. Clear
network settings: Select "YES" to clear all the
current network settings. Select "NO" to cancel.
Keep­network­connected:
If you choose to keep network connected, the
WiFi will not disconnect even you are in standby
mode or non-network mode.
Time/Date
Set the time manually or auto update, time
format, time zone and daylight. Details can be
referred to Setting date and time under Section
First-time setup.
Language
Change it as your preference. Available langu-
ages: English, Danish, Dutch, Finnish, French,
German, Italian, Norwegian, Polish, Portuguese,
Spanish, Swedish, Turkish.
Factory­Reset
Resetting all user settings to default values, so that
time and date, network configuration and presets
are lost. However, current software version of the
radio is maintained
­----------------------------------------------------------------------------------------------------
Software­Update
Auto-check setting: This option automatically
checks for new updates from time to time.
Automatic updating is enabled by default. Check
now: Search for available updates immediate-
ly. You will be asked if you want to go ahead
with download and installation of an update.
After a software upgrade, all user settings are
maintained. NOTE: Before starting a software
upgrade, ensure that the radio is plugged into
a stable main power connection. Disconnecting
power during an upgrade may permanently
damage the unit.
Setup­Wizard
With this function, you can start the setup wizard
at any time. Any parameters or stations entered
already are not deleted. For more information,
please read the Section First-time setup.
Info
View the firmware version and the radio ID.
Privacy­Policy­
View the information of Privacy Policy.
Backlight­
You may change the power - on backlight level
to High, Medium or Low. And adjust the timeout
duration which the radio turns to standby back-
light level when it has not been controlled. Press
» DIMMER « to change the brightness of the
backlight.
ENGLISH
33­ ­