Jenn-Air JCD2292HTB Guide D'utilisation Et D'entretien page 7

I
NSTALLATION
6. Align bottom of handle with lower
door tab. Press upper handle end to
door surface and firmly grasp lower
end of handle. Gently slide handle
upward until bottom of handle settles
on door surface, then reverse
direction, sliding downward to almost
engaging tab with clip.
7. Grasp the handle firmly and slide
down until it clicks. The audible click
indicates fastening clips are securely
interlocked.
To Remove:
1. Flex the handle away from the door
panel. Simultaneously place door
handle removal card underneath
the base of the lower handle. Insert
the card to the line or until it stops.
2. Grasp the lower part of the handle
firmly and lift to remove.
Handle Extensions
To Install:
• Align and clip handle extension into position on the
handle. Press the extension over the door retainers.
To Remove:
• Slide the extension down and unclip from door
retainer.
Full-Length Aluminum Handles
To Install:
1. Release top door trim (select models)
by removing Phillips screws from top
of fresh food door and retain screws
for later use.
(select models)
2. Align notches on back of handle
with retaining clips on doors.
Insert clips into notches and
slide handle down until it
contacts bottom trim.
3. Replace top door trim and Phillips
screws.
4. Repeat instructions 1-3 to install
other handle.
WARNING
To avoid possible injury and damage to property,
tape decorative panels (select models) securely into
place before removing door handles.
To Remove:
1. Release top door trim (select models)
by removing Phillips screws from top
of fresh food door and retain screws
for later use.
2. Grasp handle firmly with both
hands. Slide handle upward
approximately 3 " to release.
⁄
4
3. Repeat instructions 1-2 to
remove other handle.
To Reinstall:
1. Repeat in reverse order.
Euro Handles
This handle style is installed at the factory.
Materials Needed:
• 3 " allen wrench
⁄
32
To Remove:
• Remove set screw from
handle mounting post
using 3 " allen wrench.
⁄
32
• Repeat the procedure on
all posts to remove the
handle.
To Replace:
• Align handle with the mounting posts.
• Fully tighten all set screws to secure handle
in place.
Door Clip
6