Jenn-Air JCD2292HTB Guide D'utilisation Et D'entretien page 16

I
CE AND
Dispenser Control
(control features vary by model)
Ice Dispenser Operation
To Dispense Ice and Water:
• Select Water, Crush or Cube mode by pushing
button on dispenser control panel. A green light
above button indicates mode selection.
• Press container against dispenser pad.
When dispensing crushed ice, hold
container as close to chute as possible to
reduce spraying.
Notes
• Mode may not be changed while ice dispenser is
in operation.
• If dispenser is active for more than five minutes,
an automatic lock out sensor will shut down
power to dispenser area. See Dispenser Lock for
unlocking information.
Dispenser Lock
The Dispenser Lock prevents ice or water from
being dispensed.
To Lock Dispenser:
• Press and hold the Lock button for three seconds. A
green indicator light above button will illuminate
when the dispenser is locked.
To Unlock Dispenser:
• Hold the Lock button for three seconds. The green
indicator light above button will go out.
Water Filter Status Indicator Light
(select models)
The Water Filter Status Indicator Light serves as a
reminder to replace the water filter. A green light
indicates that the filter is in good condition. A red light
indicates the filter should be changed. Once light turns
red, it will remain red until function is reset.
To Reset Indicator:
• Press and hold both the Lock and Water
buttons simultaneously for four seconds. The
green filter status indicator light will flash
three times when the function has
successfully reset.
15
W
ATER
(select models)
(select models)
Auto Light
(select models)
The Auto Light function activates the dispenser
light at half-power when the Light Sensor
detects that the light levels in room are low.
To Activate Auto Light:
• Press Auto Light button. A green indicator light
above button illuminates when the sensor is active.
To Deactivate Auto Light:
• Press Auto Light button. The green indicator light
will go out.
Note
• When the dispenser pad is activated, the dispenser
light will operate when Auto Light is ON or OFF.
Sabbath Mode
(select models)
When activated, the Sabbath Mode deactivates the
control lights while leaving the control operational.
To Activate Sabbath Mode:
• Press and hold the Lock and Auto Light
buttons simultaneously for three to four
seconds. After three to four seconds, the
dispenser lights will turn off.
To Deactivate Sabbath Mode:
• Press and hold both the Lock and Auto Light
buttons simultaneously for three to four seconds.
After three to four seconds, the dispenser lights will
activate.
Notes
• Dispenser light will not activate during dispensing
while in this mode.
• If the power fails, the control will remain in
Sabbath Mode when power returns.