Publicité
Les langues disponibles
Les langues disponibles
Not dispensing
ice.
Not all of the doors are closed completely.
Ice will not dispense if any of the refrigerator
doors are left open.
The dispenser display
is locked.
Press and hold the Lock button for 3 seconds
to unlock the control panel and dispenser.
Ice is not selected on the dispenser.
The ice dispenser is not used often.
Ice bin is not installed correctly.
New installation.
The delivery chute is clogged
with frost or ice
fragments.
The dispenser can be set for ice or water.
Make certain that the control panel is set for
the proper operation.
Press the Ice Select
button on the control panel to cycle through
the ice options.
Infrequent
use of the ice dispenser will cause
the cubes to stick together
over time, which
wilt prevent them from properly
dispensing.
Check the ice bin for ice cubes clumping/
sticking together.
If they are, break up the ice
cubes to allow for proper operation.
Be sure to correctly
install the ice bin into
position.
Refer to Using your Refrigerator
for
removal and installation
instructions.
Wait 12 to 24 hours after icemaker
installation
for ice production
to begin. Wait
72 hours for full ice production.
Eliminate the frost or ice fragments
by
removing the ice bin and clearing
the chute
with a plastic utensil. Dispensing cubed ice
can also help prevent frost or ice fragment
buildup.
Dispensing warm
New installation.
Allow 24 hours after installation
for the water
water,
storage tank to coot completely.
The water dispenser has been used recently
The unit has a 12 oz water storage tank inside
and the storage tank was exhausted,
the refrigerator.
The refrigerator
is connected
to a hot water
Make sure the refrigerator
is connected
to a
line.
cold water pipe.
Controls are not set correctly
for conditions.
Refrigerator
or
Freezer section is too
cold.
If the temperature
is too cold, raise the
temperature
setting one increment
at a time
(refer to the Setting the Controls section).
When changing
control settings, wait 24 hours
before making additional
adjustments.
42
Publicité
