Télécharger Imprimer la page

Kenmore Elite 795.7313 Serie Guide D'utilisation Et D'entretien page 38

Publicité

Les langues disponibles

Les langues disponibles

UNDERSTANDING
SOUNDS YOU MAY HEAR
Your new refrigerator
may make sounds that your otd one
did not make. Most of the new sounds are normat. Hard
surfaces, tike the floor, wails and cabinets, can make the
sounds seem louder than they actuaity
are. The following
describes the kinds of sounds you may hear and what
may be causing them.
Clicking:
The defrost control witl click when the automatic
defrost
cycle begins and ends. The thermostat
control (or
refrigerator
control,
depending
on the model) will also
click when cycling on and off.
Rattllng:
Rattling noises may come from the flow of refrigerant,
the
water line, or items stored on top of the refrigerator.
Whooshing:
* Evaporator
fan motor circulating
the air through the
refrigerator
and freezer compartments.
*
Air being forced over the condenser by the condenser
fan.
*
Ice compartment
fan in the freezer on the left side of
the refrigerator
when the doors are open.
Gurgllng:
As each cycle ends, you may hear a gurgling
sound
caused by the refrigerant
flowing through the cooling
system.
Popping:
Contraction
and expansion
of the inside waits.
Sizzling:
Water
dripping
on the defrost
heater during a defrost
cycle.
Vibrating Noise;
If the side or back of the refrigerator
is touching
a
cabinet or wall, some of the normal vibrations
may make
an audible
sound. To eliminate
the noise, make sure that
the sides and back cannot vibrate
against any wall or
cabinet.
Dripping:
Water
running into the drain pan during the defrost cycle.
Pulsating or High-Pitched Sound:
Your refrigerator
is designed
to run more emcientty
to
keep your food items at the desired temperature.
The high
emciency
compressor
may cause your new refrigerator
to run longer than your old one, but is still more energy
emcient
than previous models. While
the refrigerator
is
running, it is normal to hear a pulsating
or high-pitched
sound.
iiii i iiHiii!i iii!iiiI i!Hi Ii!iii
iHHiiiiH! ; ii !i !iiiIiiiiii!iIi
iii!!! ii iiiii ii!! i I!!iii iiiiiiiii iiii! iiiiiH iiiii i!i! iiii ii!IH!Iii i! i i
!ii iii i
iiiii!! !iiii ii iii ii! iH! Ii!Ii!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!iii
ii!iiiii!iii iii ii i ii i!! ;iiii
ii ii !iiiii iiii iii! IIi iii! ii
i!i!!i i
iiiH/iii! i!ii0iiiiiliiiY!iiiii!i!i
Refrigerator
is not
The power supply cord is unplugged.
Firmly plug the cord into a live outlet with
cooling,
proper voltage
(see Electrical
& Grounding
Requirements).
A household fuse has blown or a circuit
Reptace the fuse or reset the circuit breaker, if
breaker
has tripped,
the problem
persists, contact an electrician.
The refrigerator
control is set to the OFF
Refer to the Setting the Controls section.
position.
The refrigerator
is in the defrost cycle.
Wait about 30 minutes for defrost cycle
to end.
The refrigerator
is in Demo Mode.
The Demo Mode attows the lights and control
display to work normaity
while disabling
the cooling system to save energy while on
the showroom
floor. To disable
Demo Mode,
open one door, then press and hold the Ultra
ice and
Refrigerator
Temp. buttons for five
seconds. Once disabled,
OFF will disappear
and the previous temperature
settings will be
displayed
(refer to Setting the Controls for
recommended
temperatures).
38

Publicité

loading