Kenmore Elite 795.7313 Serie Guide D'utilisation Et D'entretien page 29

WATER FILTER [_
CHANGE FILTER
It is recommended that you replace the water fiiten
* Approximately every 6 months.
When the water filter indicator
turns on.
* When the water dispenser output
decreases.
* When the ice cubes are smaller
than normal.
1. Remove the old water fllter.
Lower or remove the top left shelf
to allow the water filter to rotate
all the way down.
Press the push button to open the
water filter cover.
NOTE: Replacing the water filter
causes a small amount of water
(around 1 oz. or 25 co) to drain.
Place a cup under the front end
of the water filter cover to collect
any leaking water. Hotd the water
filter upright, once it is removed, to
prevent any remaining water from
spilling out of the water filter.
Putl the water filter downward
and putl out. Make sure to rotate
the filter down completely before
pulling it out of the manifold hole.
Rotate the water filter up into
position and close the cover.
The cover will click when closed
correctly.
3. After the water filter is replaced, dispense 2.5
gallons of water (flush for approximately 5 minutes)
to remove trapped air and contaminants from
the system. Do not dispense the entire 2.5 gallon
amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
4. Water Filter Bypass Plug
Keep the water filter
bypass plug. You MUST
use the water filter
bypass plug when a
replacement water filter
cartridge is not available.
2. Replace with a new water fllter.
Take the new water filter out of its packing and remove
the protective cover from the o-rings. With water filter
tabs in the horizontal position, push the new water filter
into the manifold hole until it stops.
_, CAUTION: DO NOT operate the refrigerator without
the water filter or water filter plug installed.
NOTE: To purchase a replacement water filter, visit a
Sears store or call 1-800-4-MY-HOME ®. You may also
order on-line at www.sears.com/partsdirect
29