Senix HT4QL-L Manuel De L'opérateur page 9

WARNING:
Always position the unit on the operator's right side. The
use of the unit on the operator's left side will expose the
user to hot surfaces and can result
in possible burn injury. To avoid burns from hot
surfaces, never operate unit with the bottom of the
engine above waist level.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING:
Operation of this equipment could create sparks that
can start fires around dry vegetation. A spark arrestor
may be required. The operator should contact local
fire agencies for laws or regulations relating to fire
prevention requirements.
WARNING:
Operate this unit only in a well-ventilated outdoor area.
Carbon monoxide exhaust fumes can be lethal in a
confined area.
WARNING:
Avoid accidentally starting the unit. To avoid serious
injury, the operator and the unit must be in a stable
position when pulling the starter rope.
CAUTION:
Do not overwork yourself. Take regular breaks and
change working position to ensure you can concentrate
on the work and have full control over the product.
Maintain firm footing and balance during operation.
CAUTION:
Inspect unit before each use.
Replace damaged parts. Check for fuel leaks. Make
sure all fasteners are in place and secure.
WWW.SENIXTOOLS.COM
WARNING:
Keep the cutting blades away from any cords or
extension cables. Check for foreign objects in the
hedges such as wire fences before operation.
PREPARATION
Before each use, check the following items to ensure
safe working conditions.
PROTECTIVE CLOTHING: make sure to wear the
appropriate close- fitting protective clothing such as
protective pants, gloves and safety shoes. Wear a
safety helmet with integrated hearing protection and
a face guard to provide protection against recoiling
branches.
Before starting the unit, check that the trigger switches
and automatically and quickly upon release. Also check
that the cooling air vents are not obstructed and that
both the front and rear handles are clean and dry.
CAUTION:
Remember blades coast after turn off.
The unit is equipped with a two-handed safety switch.
Always hold the unit with both hands during operation.
To operate the unit, depress and hold the front safety
switch and depress the rear trigger switch. To stop unit,
release either switch and the unit will stop.
9