Publicité
Les langues disponibles
Les langues disponibles
Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing
list are included. Inspect the product carefully to make
sure no breakage or damage occurred during shipping.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product. If any parts are damaged or missing, please
call 1-800-261-3981 for assistance.
WARNING:
Do not use this product if any parts on the packing
list are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
INCLUDED PARTS
Quantity
Item
1
Operator's manual
1
Cutting blade protective cover
1
Spark plug wrench
1
60ml bottle of oil of engine oil
WARNING:
To prevent an accidental start that could cause serious
personal injury, always disconnect the engine spark
plug wire from the spark plug when assembling parts.
WARNING:
Never install, remove, or adjust any attachments while
power head is running. Failure to stop the engine can
cause serious personal injury.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
UNPACKING
WARNING:
If any part of the unit is missing or damaged, do not
operate the unit until the damaged part is repaired
or replaced.
WWW.SENIXTOOLS.COM
UNPACKING
DO NOT discard box or packing material until all parts
are examined.
ADDING/CHECKING ENGINE OIL
CAUTION:
Attempting to start the engine before it has been
properly filled with lubricant will result in equipment
failure not covered by the warranty.
Engine lubricant has a major influence on engine
performance and service life. This engine is shipped
without engine lubricant.
Always use a 4-cycle engine lubricant that meets or
exceeds the requirements for API service classification
SJ. SAE 10W-30 or SAE 15W-40 are all acceptable
lubricants to use in this product. Non- detergent or
2-stroke engine lubricants will damage the engine and
should not be used. Check lubricant level before each
use.
ADD ENGINE OIL: INITIAL USE
1. Unscrew the oil cap from the engine and remove.
2. Pour 60 ml of oil into the oil fill hole. Replace and
tighten the oil cap.
CHECK ENGINE OIL: BEFORE EACH USE
1. Set unit on a flat level surface.
2. Unscrew the oil cap and remove.
3. Lubricant level should fall within the top of the oil fill
hole (the top of screw thread).
4. If level is low, add engine lubricant until the fluid level
rises to the top of oil fill hole (the top of screw thread).
NOTE: Do not overfill.
5. Replace and tighten the oil cap.
CAUTION:
Do not overfill. Overfilling the crankcase may cause
excessive smoke, oil loss, and engine damage.
WARNING:
Operation of this equipment could create sparks that
can start fires around dry vegetation. A spark arrestor
may be required. The operator should contact local
fire agencies for laws or regulations relating to fire
prevention requirements.
MAX
7
Publicité
