Creating a vacuum bag
1.
Insert the film roll into the roll container and pull out as much film as needed (add about 5 cm for the
seals). Then, cut the film with the integrated knife.
2.
Next, open the lid and put one end of the bag on the sealing tape.
3.
Close the lid by pressing on both sides (in some models, the pressure location is marked with a hand
symbol) – the lid will snap shut.
4.
When the lid is locked, press the "SEAL" (or "SEAL ONLY") button to seal one end of the bag. An
indicator light is on during the sealing process. Caution, if the device was not connected to the mains
before, it will not be sufficiently heated. The sealing may be incorrect. In that case, try again after the
device has heated.
5.
The sealing button indicator light goes out once the process is complete. Press the buttons on both
sides of the device to safely remove the newly-formed bag.
TRANSPORTATION AND STORAGE
During transport, the machine should be protected from shaking, crashing and turning upside down. Store it
in a properly ventilated place with dry air and without any corrosive gas.
CLEANING AND MAINTENANCE
•
Disconnect the machine from the electricity when cleaning it.
•
Use cleaner without corrosive substances to clean surface.
•
After cleaning, all parts should be able to dry before the machine is to be reused
•
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
•
Never spray the device with water jets.
CHECK REGULARLY THE DEVICE
Check regularly whether the device is damaged. If it should be damaged, please stop using it immediately and
contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare the following information:
•
Invoice number and serial number (the latter is to be found on the technical plate on the device).
•
If relevant, take a picture of the damaged, broken or defective part.
•
It will be easier for your customer service clerk to determine the source of the problem if you give
a detailed and precise description of the matter. The more detailed your information, the better
customer service will be able to solve your problem rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to
a loss of warranty!
14
INSTRUKCJA OBSŁUGI
R C VG - 2 8 E
R C VG - 2 8 P
R C VG - 3 2 E
R C VG - 3 2 P
Rev. 19.05.2017
expondo.de