Important Safeguards - Alecto BW-71 Mode D'emploi

– Read and save these instructions.
– Never use the unit without water in it.
– Do not move an appliance containing hot liquids.
– Do not immerse appliance, cord or plugs in water or other liquid.
– Place the Baby Bottle Warmer out of the reach of children and on a dry, non-
slip, horizontal surface.
– Close supervision is necessary when the unit is used near children.
– Do not let cord hang over edge of table or counter.
– Do not place on hot surfaces or in a heated oven.
– Only use the Baby Bottle Warmer when the ambient temperature is between
+7ºC and +37ºC.
– Change the water in the bottle warmer often for hygienic reasons.
Warming baby bottles:
1. Slide the control knob into position "0" (off).
2. Place the bottle in the container and fi ll the space between the bottle and the
inner container with water up to half the bottle's content.
3. Plug the Baby Bottle Warmer into the mains socket.
4. Slide the control knob into position " ". The indicator lamp " " lights to
indicate the heating operation.
5. After some minutes the milk will have reached just the right temperature for
your baby. The indicator lamp " " goes out and the indicator lamp " " lights;
the same time you will hear some beeps.
6. Slide the control knob into position "0" (off) and disconnect the Baby Bottle
Warmer from the mains socket.
7. Remove the bottle from the container and shake it a little to distribute the heat
evenly before you allow your baby to drink.
Warming baby food jars:
1. Slide the control knob into position "0" (off).
2. Remove the label and lid from the jar.
3. Place the jar in the container using the lifter and fi ll the space between the jar
and the inner container with water up to just below the top of the jar.
4. Plug the Baby Bottle Warmer into the mains socket.
5. Slide the control knob into position " ". The indicator lamp " " lights to
indicate the heating operation.
6. Use the lifter to stir the contents of the jar frequently for more rapid distribution
of heat. After a few minutes the food will have reached just the right
temperature for your baby. The indicator lamp " " goes out and the indicator
lamp " " lights.
7. Slide the control knob into position "0" (off) and disconnect the Baby Bottle
Warmer from the mains socket.
8. Remove the jar from the container.

IMPORTANT SAFEGUARDS

OPERATION
14