Makita ML702 Mode D'emploi page 4

.
OPERATING INSTRUCTIONS
Charging
For ML702, ML901 and ML902 (Fig. 1)
Charge the battery cartridge with the Makita charger before use. To remove the battery cartridge, pull out the
set plate on the torch/flashlight and grasp both sides of the cartridge while withdrawing it from the
torch/flashlight. After charging, insert the battery cartridge into the torch/flashlight and snap the set plate back
into place.
For ML903 (Fig. 2)
Charge the battery cartridge with the Makita charger before use. To remove the battery cartridge, withdraw it
from the torch/flashlight while pressing the buttons on both sides of the cartridge. After charging, insert the
battery cartridge into the torch/flashlight all the way until it locks in place with a little click.
NOTE:
Battery cartridges 9100, 9101, 9101A, 9102, 9102A can be used on ML903 if you install the set plate. Install
the set plate on ML903 with the screw provided as shown in
Fig. 3.
The following tables indicate the charging time and operating time on a single charge.
ML702
-
Battery cartridge
Operating time
1
Battery Battery Battery Battery
Approx. 120 min. Approx. 170 min. Approx. 200 min. Approx. 220 min.
9100/9120 91 01/91 01 A 91 02/91 02N9122 91 33
Battery cartridge
Operating time
.
ML902
Battery Battery Battery Battery
9000 9001 9002 9033
Approx. 120 min. Approx. 170 min. Approx. 200 min. Approx. 220 min.
Head angle (Fig. 4)
The head angle can be adjusted in four stages. Adjust as desired.
Replacing bulb (Fig. 5 & 6)
CAUTION:
The bulb is very
hot
immediately after operation. Wait until the bulb cools
off
before attempting to replace it.
First, turn the ring counterclockwise and remove the reflector. Remove the bulb holder by turning it
counterclockwise. Then replace the bulb.
.
MAINTENANCE
To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by Makita
Authorized Service Center.
4