Beper P101FOR001 Mode D'emploi page 20

Microwave oven with grill Use instructions
Problems solving
In case of breakdown, before contacting the manufacturer or the technical assistance centre, check the following
indications:
Problem
The microwave oven does not
turn on
The microwave oven does not
heat
The turnplate is noisy when
the mircowave oven is in use
Interference of the microwave
oven with the reception of te-
levision
Low light
Steam builds up on the door,
warm air come out from ope-
nings
The oven is turned on acci-
dentally when empty
TECHNICAL DATA
Capacity: 20 litres
Microwave power: input 1100 W
Output: 700W
Grill output: 900W
Frequency: 2450 MHz
Power supply: 230V~50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
Possible causes
The cord supply is not cor-
rectly connected to the so-
cket
The fuse blows or the circuit
breaker trips
Problem with the output ter-
minal
The door is not correctly
closed
The wheels are dirty or food
residue in the botton the mir-
cowave oven
It is possible that there is interference to radio or television for the operation
of the microwave. This is a phenomenon similar to that which may occur with
small appliances. This is normal.
While cooking in a microwave oven at low pressure, the oven light may de-
crease. This is normal.
During cooking it is possible that steam escapes from the food. Part of this
steam is expelled through the openings, but the vapors may accumulate on
cold surfaces such as door. This is normal.
Turning on the microwave oven when empty does not create any damage to
the appliance, but this is avoid.
20
Solutions
Disconnect from the socket, and connect
again after 10 seconds
Replace the fuse or reset the circuit breaker
(request the intervention of skilled personnel)
Check the outlet with another device
Close the door correctly
Please refer to the paragraph « cleaning and
care»