RISCO Group EL-5803 Instructions D'installation page 11

WARNING:
This detector is not suitable for installation in a hazardous location, as defined in the national
electrical code. Do not use detector in an outlet controlled by a wall switch.
8. Line up the side slot of the bracket and the detector. Push the detector onto the
mounting bracket and turn it clockwise to secure it into place.
Insert the locking pin in order to secure the mounting bracket to the detector (see
Figure 7).
9. Pull the detector outward to make sure it is securely attached to the mounting bracket.
RED INDICATOR
When the red LED indicator (see Figure 9) flashes once in 30 seconds, it indicates the
detector is operating normally. When the red LED is illuminated continuously, and
simultaneously an audible alarm sounds, this indicates the detector is responding to an
alarm trigger.
DETECTOR PARAMETERS
The following detector parameters can be defined from the system receiver:
Parameter
Operational Mode:
Supervision Time:
See your system receiver's installation / configuration manual for more information about
defining detector parameters.
All manuals and user guides at all-guidesbox.com
Option
Smoke only, Heat only or Smoke and Heat
1-255
1 & 2-Way Smoke & Heat Detector
EN
11