Publicité
Les langues disponibles
Les langues disponibles
Programming
Remote Control
Pre-programmed remote control included, no need to program the
remote.
To add or reprogram a remote control, follow the instructions below.
Program Using the Garage Door Opener LEARN Button
1.
Press and release the LEARN Button on the garage door opener.
2.
Press and hold the button on the remote control that you wish to
use. Release the button when the garage door opener lights
blink or two clicks are heard.
Note: Remote may vary.
Program Using the Multi-Function or Motion-Detecting Control
Panel
1.
Press the LEARN button on the door control to enter
programming mode.
2.
Press the LEARN button again, the command LED will flash once.
3.
Press the button on the remote control that you wish to operate
your garage door.
Wireless Keyless Entry
Refer to the instructions provided with your keyless entry OR go to
Chamberlain.com to download instructions.
LEARN Button
Command LED
Multi-Function Control Panel
HomeLink
®
If your vehicle is equipped with HomeLink
(not included) may be necessary for certain vehicles. Visit
bridge.chamberlain.com to find out if a Bridge is needed.
To Erase the Memory
Erase ALL Remote Controls and Keyless Entries
Press and hold the LEARN button until the LED goes out
(approximately 6 seconds).
All remote controls and keyless entries are now erased.
Erase ALL Devices (Including myQ® enabled accessories)
1.
Press and hold the LEARN button until the LED goes out
(approximately 6 seconds).
2.
Immediately press and hold the LEARN button until the LED goes
out. All codes are now erased.
Erase the Wi-Fi Network from the Garage Door Opener
Press and hold the adjustment button until 3 beeps are heard
(approximately 6 seconds).
Erase the Camera Settings - Models B4655T, B6713T, B6753T and
B6755T
Press and hold the reset button on the side of the camera for 10
seconds. The LED light will turn off, then flash red.
You will need to set up your camera again after resetting it.
LEARN Button
Adjustment Button
LEARN Button
Command LED
Motion-Detecting Control Panel
, a Compatibility Bridge™
®
7
Publicité
