Publicité
Les langues disponibles
Les langues disponibles
ordering spare parts:
• Type of machine
• Item number of the machine
14. Fault finding
Caution!
Switch off the machine and pull out the mains plug
before commencing fault finding.
The following table shows fault symptoms and describes
how they can be rectified if your machine is not function-
ing properly. If this does not help you localise and rectify
the problem, contact your service workshop..
Cause
Chainsaw does not operate
Chainsaw operates irregularly
Saw chain dry
Chain/guide rail hot
Chainsaw jumps up, vibrates or
does not saw properly
For this electric tool, the company provides the end user - independently from the retailer's obligations resulting from
the purchasing contract - with the following warranties:
The warranty period is 60 months beginning from the hand-over of the device which has to be proved by the original
purchasing document. Wearing parts and defects caused by the use of non fitting accessories, repair with parts that
are not original parts of the manufacturer, use of force, strokes and breaking as well as mischievous overloading of
the motor are excluded from this warranty. Warranty replacement does only include defective parts, not complete
devices. Warranty repair shall exclusively be carried out by authorized service partners or by the company's customer
service. In the case of any intervention of not authorized personnel, the warranty will be held void. The warranty shall
not apply to commercial use of the product.
All postage or delivery costs as well as any other subsequent expenses will be borne by the customer.
GB | Operating Instructions
Fault
No current supply
Defective outlet
Extension cable damaged
Defective fuse
Mains cable damaged
External loose connection
Internal loose connection
Defective on/off switch
No oil in the tank
Ventilation in the oil tank cap clogged
Oil tank flow channel clogged
No oil in the tank
Ventilation in the oil tank cap clogged
Oil tank flow channel clogged
Dull chain
Chain tension too loose
Dull chain
Chain worn out
Saw teeth pulling in the wrong
direction
15. Warranty
14
Remedy
Check current supply.
Try a different source of current,
change as necessary.
Check cable, replace if necessary.
Replace fuse
Take saw to a specialty workshop
Take saw to a specialty workshop
Take saw to a specialty workshop
Take saw to a specialty workshop
Re-fill oil
Clean oil tank cap
Unclog oil flow channel
Re-fill oil
Clean oil tank cap
Unclog oil flow channel
Re-sharpen or replace chain
Adjust chain tension
Re-sharpen or replace chain
Replace chain
Re-mount saw chain with
teeth in the correct direction
Publicité
