EUROM SPV550i-Prof Instructions De Service page 22

Pump does not
start or
suddenly stops
during
operations.
Turns of the
stator is burnt
out.
Pump produces
suddenly less
water.
Warranty
A normal warranty for production & material errors apply to the submersible pump
you purchased.
The following damages and faults are excluded from the warranty:
 Wear & tear and defects of rotating mechanical seals due to dry-run or the
presence of certain substances and/or objects in the water
 Blockage of the vane due to strange objects
 Transport damage
 Damage due to incompetent use
 Faults that unprofessional people tried to repair in vain or are caused by
incompetent repair
 Damage due to overheating
Opening the pump by unauthorised people as well as making changes or additions to
the pump will cancel the warranty and the liability of the supplier, importer and
manufacturer.
Too little pump capacity due to
dirt or sandy
Thermal protection stops the
pump due to overheating.
The water is too hot.
Power outage
Plug out of the socket
Dirt or little stones in the water
supply
Vane is blocked.
The coil of the stator has burnt
out.
Short-circuit, possibly due to a
leak
Blocked vane
Pump is started too frequently.
Pump is overloaded.
Suction openings are blocked.
Clean the pump and have worn-
out parts replaced.
See Overheating Protection
section.
Maximum water temperature is
40°C.
Check the fuses and the earth
leakage circuit breaker.
Insert the plug.
Remove dirt and little stones.
Remove the dirt.
Rewind and overhaul the coil.
In all cases: Remove the reason
and have the stator rewound.
Send the pump for repair to your
supplier or service station.
Clean the openings.
22