Bertazzoni REF30BMBN Serie Manuel D'installation page 41

countersinking the handle hardware into
the back of the panel, as shown below.
The door handle mounting screws must
not protrude either.
REF30BMB...N...
REF30BMB...N...
REF36BMBZPNV
REF36BMBZPNV
REF36FDBZPNV/24
REF36FDBZPNV
PREPARING THE FREEZER DRAWER PANEL
"
REF30BMBZPNV: 29 3/4" (756mm)
REF30BMBPNB: 29 3/4" (756mm)
REF36BMBZPNV: 35 3/4" (908mm)
REF36FDBZPNV/24: 35 11/16" (907mm)
WARNING:
The handle mounting holes will have to be
adjusted based on the handles to be used in
the kitchen design.
WARNING:
The minimum door thickness must be ¾"
(19 mm).
WARNING:
On the French Door Bottom Mount
REF36FDBZPNV/24 model can only be
mounted panels with a thickness up to 3/4"
(19 mm).
WARNING:
To prevent damage to the finished surface
of the panel, use screws suitable for the
door thickness.
EN
41