Party Light & Sound PARTY-BAGGY Manuel D'utilisation page 3

EN
1. PRIOR to using the unit for the first time, please charge fully the battery
2. Charge the battery regularly after each use. Don't wait until it is discharged!
3. DON'T allow the battery to discharge completely, otherwise it will lose 20% of its capacity or
even be totally damaged!
If the voltage becomes too low, the internal circuits are not powered anymore and it will become
impossible to recharge the battery!
4. If you don't use the unit for a longer period of time, it is recommended to charge it at 40% of
its capacity and check/charge it once per month.
We cannot be held responsible for damaged batteries further to the non-observance of these
Location of Controls
1. 3.5mm Auxiliary Input Port
2. LED indicator
3. Micro-USB Charging Port
4. Light effect switch
5. ON/OFF switch
Using the speaker
Flip the on/off switch to the ON position to switch the speaker on. The speaker will enter into Bluetooth pairing
mode. The speaker will automatically re-connect to any nearby, previously-paired device when the Bluetooth
function is enabled. Flip the on/off switch to the OFF position to switch the speaker off.
Operation of the LED light effect
Press button 4 to cycle through the light modes.
1. RGB Cycling colors
2. Solid Red
3. Dancing Red
4. Solid Green
5. Dancing Green
6. Solid Blue
7. Dancing Blue
8. Random RGB colors
Keep the button 4 pressed to switch off the lights.
For best effects, turn up the volume.
Playing Music
To play music, you must be connected to a Bluetooth-enabled device or connected via an AUX cable (See the
chapters "Bluetooth Pairing" and "Use with a Wired Device" of this user manual). Once connected, audio play-
back and volume adjustment can be controlled via your paired media-playing device.
Bluetooth Pairing
1. Power the speaker ON. A tone will be heard and the LED indicator will quickly flash BLUE.
2. Enable the Bluetooth search function on your mobile device. Select "PARTY-BAGGY30" in the list of found
devices.
3. After successful pairing, a tone will be heard and the LED indicator will slowly flash BLUE .
Use with Wired Device
Insert one connector of a 3.5 mm auxiliary cable into the 3.5mm auxiliary input port on the top of the speaker.
Insert the other connector into the headphone jack of your media-playing device. The LED indicator will light
BLUE when an AUX cable is connected.
All Bluetooth pairings will be disconnected while the 3.5mm AUX jack is connected.
IMPORTANT NOTE ON LITHIUM-ION BATTERIES
** BATTERIES ARE NOT COVERED BY THE WARRANTY **
basic rules.
1 2 4
3
AUX DC 5V ON OFF
5
3