Publicité
Les langues disponibles
Les langues disponibles
Problem
Spots on stainless steel or sil-
ver.
Spots or films on the dishes.
28
Possible causes
Dishes loaded incorrectly.
Glasses and cups have toppled
over during the program.
The filters are not fitted cor-
rectly.
Drainage pump stop missing.
Some foodstuffs, such as mus-
tard, mayonnaise, lemon, vineg-
ar, salt and dressings, can
cause spots on stainless steel
if left for too long.
All stainless steel can cause
spots on silver if they come into
contact during dishwashing.
Aluminium can also cause spots
on dishes.
The water softener is leaking
salt.
Incorrect water softener setting.
Incorrect rinse aid dosage set-
ting.
Salt compartment empty.
3-in-1/ All-in-one detergent is
used and the setting TAB (3-in-
1/ All-in-one detergent) is activ-
ated.
Too high temperature and/or
too much detergent can cause
etching on crystal. Unfortu-
nately, this cannot be repaired,
only prevented.
Action
Do not cover porcelain with
large bowls or the like. Avoid
placing very tall glasses in the
corners of the baskets.
Place dishes to sit steady.
Check that the filter handle is
locked in the stop position.
Check that the coloured stop
on the right in the bottom drain
is in place. See the chapter Care
and cleaning.
Rinse off these types of food-
stuffs if not starting the dish-
washer immediately. Consider
using the One hour program
program with the SpeedWash
option.
In order to avoid marks and tar-
nishing, separate dishes made
from different metals, such as
silver, stainless steel and alu-
minium.
Check that the salt compart-
ment lid is properly tightened.
Otherwise call the service de-
partment.
See the chapter Settings.
See the chapter Settings.
Top up with salt. See the
chapter Before washing for the
first time.
Inactivate the setting TAB (3-in-
1/ All-in-one detergent) and top
up salt and rinse aid.
Wash crystal at a low temperat-
ure and with a conservative
amount of detergent. Contact
the detergent manufacturer.
Publicité
