VOLTCRAFT LSP-2165 Mode D'emploi page 18

3. INTENDED USE
The lab mains unit with electronic stabilisation serves as a potential-free voltage source to operate low-voltage con-
sumers.
The output voltage and the output current can be set via a rotary encoder each (for setting area, see chapter "Techni-
cal data"). A display shows the output voltage and the output current. The direct voltage output of the lab mains unit is
available at two 4 mm sockets on the front.
The lab mains unit is set up in protection class I and must only be connected and operated at a protective contact
mains socket of the public mains.
The power intake of the consumer must not exceed the rated current of the mains unit (see chapter "Technical data").
The safety notes and all other information in these operating instructions always have to be observed. Read the op-
erating instructions precisely and keep them. Only pass the product on to any third parties together with the operating
instructions.
This product complies with the statutory national and European requirements.
4. SCOPE OF DELIVERY
• Lab mains unit
• Mains cable
• Operating instructions
18