Publicité
Les langues disponibles
Les langues disponibles
Installation
UNPACKING
When transporting the slicer, ensure that the packaging is fully intact; if this is not the case, please advise
the courier or local dealer immediately. In order to remove the slicer from the packaging, please proceed as
follows:
•
Cut and remove the plastic bands.
•
Open the box and take out the instruction booklet.
•
Proceed as described below:
- Remove the protective cardboard covers from inside the box.
- Lift the machine with care and place on a solid surface.
- Remove the plastic bag in which the slicer is wrapped.
- Check that all components and this instruction booklet are present and fully intact.
Should any faults be noted, such as:
•
Dents to the frame or guards.
•
Controls that are either not working or broken.
•
Missing items or other problems.
Please advise the courier, manufacturer and service centre immediately.
Carefully dispose of packaging components (bands, cardboard, polystyrene, polyethylene bags, etc.).
Packaging components (bands, cardboard, polyethylene, etc.) can be treated as municipal solid waste and
therefore disposed of without any problem. In any event, it is preferable to sort products prior to disposal in
accordance with current recycling regulations.
DO NOT DUMP PACKAGING! DISPOSE OF WASTE RESPONSIBLY!
DESCRIPTION OF THE SLICER
1. Slice receiving surface.
2. Slice deflector.
3. Pusher.
4. Sliding product holder.
5. Carriage.
6. Flywheel operating handle.
7. Flywheel.
8. Base.
9. Blade guard.
10. Pusher vertical slide lever.
11. Sliding product holder fast forward lever.
12. Sliding product holder operating handwheel.
13. Slice thickness control graduated knob.
14. Blade cover.
15. Supporting foot.
16. Blade.
8
Publicité
