Remote Controller; Preparation Before Operation; Auto Restart Function - Mitsubishi Electric MSZ-GA50VA Notice D'utilisation

NAME OF EACH PART

Remote controller

Signal transmitting section
Operation display section
ON/OFF (operate/
stop) button
Open the front lid.
(This diagram shows an overall view.)
VANE button
(Horizontal vane button)
Operation select button
ECONO COOL button
WIDE VANE button
(Vertical vane button)
RESET button
4
˚C
CLOCK
TOO TOO
ON/OFF
WARM COOL
Temperature buttons
NOTE
Use the remote controller provided with
the unit only.
Do not use other remote controller.
Fan speed control button
Off-timer button
On-timer button
HR.button
MIN.button
(Time set buttons)
LONG button
CLOCK set button

PREPARATION BEFORE OPERATION

Auto restart function

I
These models are equipped with an auto restart function. If you do not want to use this function,
please consult the service representative because the setting of the unit needs to be changed.
Auto restart function is ...
When the indoor unit is controlled with the remote controller, the operation mode, the set temperature and the fan speed are
stored in the memory. If a power failure occurs or the main power is turned off during operation, "Auto restart function" sets
automatically to start operating in the same mode as the one set with the remote controller just before the shutoff of the main
power. (Refer to page 6 for details.)
Outdoor unit
I
Insert the power supply plug into the power outlet and/or turn the breaker on.
WARNING:
Remove dirt from the power supply plug and insert the plug securely.
If dirt adheres to the plug or insertion is incomplete, it may cause a fire or an electric shock.