Energy Saving; Cleaning And Maintenance - Philips GC9400 Série Mode D'emploi

English
8
Vertical ironing
Warning: Hot steam is emitted from the iron. Never attempt to remove wrinkles from
a garment while someone is wearing it (Fig. 13). Do not apply steam near your or
someone else's hand.
You can use the steam iron in vertical position to remove wrinkles from hanging fabrics.
1 Hold the iron in vertical position, press the steam trigger and touch the garment lightly with the
soleplate and move the iron up and down (Fig. 14).
Safe rest
Resting the iron while rearranging your garment
While rearranging your garment, you can rest the iron either on the iron platform or horizontally on the
ironing board (Fig. 6). The OptimalTEMP technology ensures the soleplate will not damage the ironing
board cover.

Energy saving

Eco mode
By using the ECO mode (reduced amount of steam), you can save energy without compromising on
the ironing result.
1 To activate the ECO mode, press the ECO button (Fig. 15). The green ECO light goes on.
2 To deactivate the ECO mode, press the ECO button again. The green ECO light goes out.
Auto shut-off
- To save energy, the appliance switches off automatically when it has not been used for 10 minutes.
The light in the on/off button starts to flash.
-
To activate the appliance again, press the on/off button. The appliance then starts to heat up
again.
Warning: Never leave the appliance unattended when it is connected to the mains.
Always unplug the appliance after use.

Cleaning and maintenance

Descaling the appliance
Perform the descaling procedure when the EASY DE-CALC light starts to flash (Fig. 16). This helps to
prolong the lifetime of the appliance and optimizes the ironing performance.
Note: If your water is hard, increase the descaling frequency.
Warning: To avoid the risk of burns, unplug the appliance and let it cool down for at least
two hours before you perform the descaling procedure (Fig. 17).
Tip: When you perform the descaling procedure, place the appliance on the edge of the table top or
near the sink. Water may flow out of the appliance when the EASY DE-CALC knob is being opened.
1 Hold a cup (with a capacity of at least 350 ml) under the EASY DE-CALC knob and turn the knob
anti-clockwise. Remove the EASY DE-CALC knob and let the water with scale particles flow into the
cup. (Fig. 18)