Beamz Butterfly II 6x3W RGBAWP IR Manuel D'instructions page 4

HOW TO CONTROL
REMOTE CONTROL
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding
can cause greater accumulation of dirt on the unit's optics.

Make sure the area below the installation place is free from unwanted persons during servicing

Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any deformation

The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is
detected

In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned
monthly.

The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.

Clean with soft cloth using normal glass cleaning fluid.

Always dry the parts carefully.

Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!
4
You can control this fixture without the use of a controller because this feature
provides automatic and sound activated mode.
AUTO
SOUND : Fixture responds to the beat of the music. Turn the music on and adjust
the microphone sensitivity knob until the product responds to the beat of the
music.
DMX : No function
AUTO : Press <AUTO> for setting of automatic program.
SOUND : Press <SOUND> for setting of sound active program.
SPEED : Press <SPEED> and then press + / - for setting speed.
BLACK OUT : Press <BLACKOUT> for setting On / Off (return the present program).
FLASH : Press <FLASH> and then press + / - for setting flash speed.
The remote control is supplied with a battery inserted. An insulating foil between the
battery and the battery contacts prevents the battery from being discharged during
storage. Prior to the first operation remove the foil from the battery support on the rear
side of the remote control. Otherwise operation of the remote control is not possible.
If the range of the remote control decreases, replace the battery. For this purpose, on the rear side of
the remote control press the small bar with the groove to the right (1)
and at the same time remove the battery support (2). For operation,
one 3 V button cell type CR2025 is required. When inserting, pay
attention that the positive pole of the button cell shows upwards in the
support.
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
: Fixture shown the preset program.