English
- Start up the lawnmower.
- Cut as shown in the diagram:
- Cut from point 1 to 2.
- Turn towards your right to point 3.
- Turn towards the left to point 4.
- Repeat the sequence as many times as necessary.
4
2
Attention! Never work towards the cable.
Empty the catcher when full. You will notice that the
catcher is full because the machine will start cutting
less well, leaving more cut grass on the ground.
When emptying the catcher, always stop the machine,
wait for the blade to stop and then empty the catcher.
Reccomendations:
- Always cut when the grass is dry. Avoid cutting the
grass when it is wet.
- Cut less than 2 cm each time you cut the grass. If
the grass is very high, pass the lawnmower as
many times as it is necessary to achieve the
desired result. This way you will not force the
machine.
3
1
36/124
- Cut the grass frequently, at least once or twice a
week during spring and summer.
- Do not always cut the grass the same way. It is
better to cut the grass in different directions.
- If you have to transport the machine from one
working area to another, always turn the engine off.
- Sharpening the blade: An unsharpened blade will
make cutting more difficult. A bad cut will result in
a bad cut and that the grass will yellow.
8. MAINTENANCE AND SERVICE
Carry out random inspections on the machine to
ensure an efficient use of the machine. For a complete
maintenance take the machine to your nearest service
agent.
It is always necesaary to stop the machine, wait
for the blades to stop before carrying out any cleaning
or maintenance work on the machine and when
transporting the machine.
Never attempt to carry out any maintenance work
on the machine if the machine is running. Carry out
all maintenance work on a flat surface and on a clear
surface.
Always carry out maintenance work with the
machine unplugged from the mains.
WARNING! Do not change the machine or its cutting
elements. An incorrect change to these elements
could cause SEVERE PERSONAL DAMAGES OR
DEATH.