Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Adding salt
WATER HARDNESS
degrees Clark
0 - 10
0 - 8
8 - 22
10 - 28
22 - 45
28 - 56
56 - 75
45 - 60
This machine is equipped with a water softener. To use the water
softener, fill the dishwasher with salt.
1. Remove the bottom basket and then unscrew the cap from the
reservoir.
2. Before filling the reservoir for the first time, pour in one litre of water.
3. Insert the funnel into the reservoir opening. Pour in approximately
1 kg of salt. It is normal for a little water to flow out of the opening
when doing this. Note! Clear up any spilled salt and always run a
full cycle immediately afterwards to prevent damage to the bottom.
4. Screw the cap back on firmly.
Note! Always fill the salt reservoir and adjust the water hardness setting
before using the dishwasher. Refill the salt reservoir when the water
softener indicator lights up. It is possible that the light will remain lit for
a short while after the salt reservoir is filled. It will go out automatically
when enough salt has been dissolved in the water.
Setting the salt consumption
• Unscrew the cap from the salt reservoir.
• In de opening of the reservoir, you will find a ring bearing an arrow.
Turn the ring towards - or +, depending on the hardness of the
water.
Adjust the salt consumption according to the table below:
ºdH
mmol/l
0 - 1.4
1.4 - 3.9
3.9 - 8
8 - 11
Your local water authority can inform you how hard your mains water is.
salt consumption
setting
(grams/cycle)
no salt required
0
- position
20
central position
40
+ position
60
autonomy
(cycles/1 kg)
/
50
25
16
GB 11
Publicité
