Aiwa AV-D30 Mode D'emploi page 12

,
MANUAL TUNING
1>
I
f
1 Press the TUNER button repeatedly to select the
desired band.
~
The display changes to frequency indications after indicating
band and video source (V1, V2 or V3) for two seconds.
When the TUNER button is pressed while the power is off,
the power is turned on directly.
2 Press the
UPA
or DOWNY button to select a
station.
Each time the button is pressed, the frequency changes.
[
When a station is received, "TUNE" is displayed for two
seconds. During FM stereo reception, [{(m)]) is displayed.
,
To search for a station quickly (Auto Search)
Keep the UPA or DOWNT button pressed until the tuner starts
searching for a station. After tuning in to a station, the search
stops.
To stop the Auto Search manually, press the UPA or DOWNY
button,
The Auto Search mqy not stop at stations with '"very weak
signals.
When an FM stereo broadcast contains noise
Press the MONO TUNER button on the remote control so that
"MONO appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button so that "MONO?'
disappears.
DIRECT TUNING
f?====%
I
DOWNY, UPA
When you know the frequency of the desired station, you can
tune in directly to the station.
1 Press the TUNER button to select a band.
2 Press the TUNER button and hold it down until
"
"flashes on the display (DirectTuning Mode).
.....
3 Press the appropriate numbered buttons,to tune
in to the desired station.
Example:
To tune in to 106.50 MHz, press 1, 0, 6, 5 and O buttons.
To tune in to 95.20 MHz, press 9, 5, 2 and Q buttons.
To
cancel the Direct tuning mode
Press the UPA or DOWNY button.
When using the remote control
Carry out steps 1 and 2 above, and press the numbered buttons
on the remote control to tune in to the desired station.
When entering a frequency out of tuning range, the value
flashes for two seconds and then goes off. Check the frequency
and repeat step 3 correctly.
When entering" a frequenc~ not covered by the tuning interval,
the value is automatically rounded up or down to the closest
one covered by it.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation
system is 9 kHz/step, change the tuning interval.
Hold down the TUNER button and press the POWER button
immediately. Note that the unit is set to the Direct Tuning mode
if the TUNER button is pressed and held down for about half
a second.
To reset the interval, repeat this procedure.