Publicité
Les langues disponibles
Les langues disponibles
W 950 Flexio/ W 975 Flexio
W 950 Flexio/ W 975 Flexio
•
Hold the spray lance over the material
container and pull the trigger to pump the
remaining paint out of the system into the
material container.
•
Turn the machine off. (Set the multifunction
switch to "OFF")
•
Place a container with water in front of the
device and attach the suction hose.
•
Click the spray lance into the holder and
slew it over the container with water. (Fig. 9)
Attention! During automatic
cleaning of the pump do not
leave the device unattended. The
hoses could disconnect during
the cleaning operation leading to
water damage.
•
Set the multifunction switch to "FILL/CLEAN".
•
Pull the trigger (fig. 10, 1) and push the stop
(2) upwards to secure the trigger. Allow water
to circulate through the machine for about 10
minutes in order to clean the pump and hoses.
If necessary renew the water.
•
Release the stop by pulling the trigger.
•
Turn the machine off. (Set the multifunction
switch to "OFF")
•
Take the spray lance out of the holder and
remove the cover (fig. 11, 1) from the spray
head.
•
Detach the material hose (fig. 11, 2) from the
slot on the spray head.
1
1
EN
2
2
45
45
Publicité
