Publicité
Les langues disponibles
Les langues disponibles
EN
19. Rectifying errors when working with the spray lance
Problem
No coating
material
emerges from
the nozzle
Coating
material drips
from the nozzle
Atomisation too
coarse
48
48
Cause
•
Nozzle clogged
•
Material volume setting turned
too far to the left
•
When trigger is not completely
pushed through, the feed pump
is not switched on
•
The control hose not inserted into
the grab handle
•
Control hose blocked or
damaged
•
Container empty
•
Suction hose or suction filter is
blocked
•
The suction hose is
disconnected from the basic
device
•
The suction hose is not in the
paint
•
Pull wire is disconnected or not
tight enough
•
The material hose is
disconnected from the spray
head or basic device
•
Pump is defect
•
Coating material assembly at air
cap, nozzle or needle
•
Nozzle loose
•
Nozzle seal worn
•
Nozzle worn
•
Pull wire is too tight
•
Material volume too large
Material volume setting turned
too far to the right
•
Nozzle contaminated
•
Viscosity of coating material too
high
•
Air filter heavily soiled
•
At high quantity of material,
narrow spray jet selected (white)
W 950 Flexio/ W 975 Flexio
W 950 Flexio/ W 975 Flexio
Remedy
•
Clean
•
Turn to the right
•
Push trigger through
completely
•
Insert the control hose
(fig.3,1)
•
Clean or replace
•
New paint container
•
Clean
•
Reattach the suction hose
•
Immerse the suction hose
•
Connect and tighten the pull
wire
•
Reattach the material hose
•
Please contact Wagner
Service
•
Clean
•
Union nut tighten
•
Change
•
Change
•
Reduce tension
•
Turn the material volume
setting to the left
•
Clean
•
Dilute further
•
Change
•
Switch to wide spray jet
(black/yellow)
Publicité
