Publicité
Les langues disponibles
Les langues disponibles
EN
Problem
Problem
Atomisation too
coarse
Spray jet pulsates
Coating material
causes "paint tears"
Too much fog of
coating material
(Overspray)
Paint in the
ventilating hose
27.
Maintenance
Check the air filter (fig. 30, 1) after use and replace depending on how soiled it is.
Insert a new air filter (order no. 2310 812) and
replace the lid (2).
WARNING! Never operate the
i
machine without the air filter;
dirt could be sucked in and
interfere with the function of
the machine.
To make assembly easier, apply lubricant
(enclosed) to the specified areas after
cleaning (fig. 31).
56
56
Cause
Cause
•
Material volume too large
Material volume adjusting screw
turned too far to the right
•
Nozzle contaminated
•
Coating material too thick
•
Air filter heavily soiled
•
Too little pressure build-up in
container
•
Coating material in container
running out
•
Nozzle seal is missing or worn
•
Air filter heavily soiled
•
Too much coating material
applied.
•
Distance to the object too large
•
Too much coating material
applied
•
Diaphragm soiled
•
Diaphragm defective
W 950 Flexio/ W 975 Flexio
W 950 Flexio/ W 975 Flexio
Remedy
Remedy
•
Turn material volume
adjusting screw to the
left
•
Clean
•
Dilute
•
Change
•
Tighten container
•
Refill
•
Insert an intact nozzle
seal
•
Change
•
Turn material volume
adjusting screw to the
left
•
Reduce distance
•
Turn material volume
adjusting screw to the
left
•
Clean the diaphragm
•
Replace the diaphragm
2
1
Publicité
