Publicité
Les langues disponibles
Les langues disponibles
[B] Insert a short bar (± 19 cm/7.3"); with pre-drilled holes) (2x).
[C] Align the holes and secure the connection with a bolt and wing nut. Place a washer on either side
of the bar (2x).
[D] Slide the assembly [A] over the truss.
[E] Connect the two trusses as indicated.
[F] Secure the connection with a bolt and wing nut. Place a washer on either side of the bar (2x).
[G] Secure the vertical bar in the T-joints with the butterfly nuts (4x).
Side Bars
1. Locate an 80 cm/31.5" top bar and insert a short bar (± 19 cm/7.3"; with pre-drilled holes). Align
the holes and secure the connection with a bolt and wing nut. Place a washer on either side of the
bar.
2. Slide the whole into the 165 cm/64" bottom bar, align the holes and secure the connection with a
bolt and wing nut. Place a washer on either side of the bar.
3. Secure the butterfly nut for additional strength.
4. Slide two T-joints (with safety pin) over the top bar. Do not secure them yet.
5. Repeat to assemble the second side bar.
Tripod
1. Open a tripod and secure it with the butterfly nut.
2. Slide the bottom part (with pre-drilled holes) of a side bar (see
3. Determine the desired height. Insert a safety pin through the applicable pre-drilled hole. The safety
pin will rest on the tripod (see illustration).
4. Secure the butterfly nut of the tripod.
5. Repeat for the other side.
Mounting the Truss
This step should be performed by two adult persons.
1. Insert the truss (see
2. Insert the safety pin through the T-joints and secure the butterfly nuts of the trusses.
3. Determine the desired height, make sure the truss is level and secure the butterfly nuts on the side
bars.
T-Bar
1. Place a T-bar on top of each side bar. Rotate it in the desired angle and secure it with the butterfly
nut.
2. Use the included bolts to attach devices (not incl.) to the T-bars.
6.
Cleaning and Maintenance
All screws should be tightened and free of corrosion.
The device should not be deformed, modified or tampered with; e.g. do not drill extra holes in mounting
supports, do not change the location of the connections...
Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7.
Technical Specifications
colour
max. load
max. height
width
tube Ø bridge
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device.
For more info concerning this product and the latest version of this manual, please visit our website
www.hqpower.eu.
The information in this manual is subject to change without prior notice.
V. 01 – 12/03/2013
VDL9LS
) simultaneously into the two T-joints of the side bars.
black
80 kg (175 lb)
2.75 – 3.5 m (9 – 11.5 ft)
1.53 m or 3.05 m (5 or 10 ft)
35 mm
24 kg (53 lb)
6
) in the tripod.
©Velleman nv
Publicité
