Abus TVIP31000 Manuel Utilisateur page 86

4.6 Using the microSD slot
Disconnect the power supply before inserting the
microSD card.
The microSD card can only be inserted into the socket in
a specific position. The card protrudes out of the slot by
about 4 mm when positioned correctly.
The card is detected by the camera when the power
supply is reconnected, and can then be used as desired.
The microSD card cannot be replaced when the
system is in operation!
4.7 Status displays
LED
Network
Power supply
W-LAN
SD card
4.8 Restoring the factory settings
Camera restart
Restoring the factory settings
Colour Meaning
Green Constantly green when network connection is active
Orange Flashes when network activity is detected (data traffic active)
Red Constantly red during camera start-up; active for 30 seconds
when WPS is active
Blue Constantly blue after successful camera start-up
Violet Flashes during WPS configuration or firmware update
Off When reset button is pressed
Green Constantly green when W-LAN connection is active
Flashes when data traffic via W-LAN is active
Orange Constantly lit when SD card is available
Flashes during the write process
Press the button until the blue LED goes out -> constantly red
during camera restart -> constantly blue after successful
camera restart
Press the button until the LED lights up blue constantly ->
constantly blue after successful camera restart
86