Publicité
Les langues disponibles
Les langues disponibles
EN
EN
ACCESSORIES
ACCESSORIES
The jack is supplied with two extensions or height adapters (120 mm the long extension, 70 mm the short extension), a
circular tooth plate (10 mm plate) and an extension holder.
USE
USE
IMPOR
IMPORT T ANT
ANT: The jack must be used and operated in the horizontal position only in order not to compromise its
: The jack must be used and operated in the horizontal position only in order not to compromise its
operation.
operation.
- Follow the safety rules given in this manual to the letter.
1. Position the jack beneath the support point indicated in the vehicle manufacturer`s manual.
The manufacturer shall not be held liable for any damage to the lifted vehicle or other property, or for injuries,
caused by incorrect or improper use of the jack.
2. The handle positioning lever (A) DWG.13
locking system, allowing the operator to choose one of the three possible handle positions.
3. When the control (B) DWG.13
(B) DWG.13 is perfectly centred, the jack is in the rest position.
4. Turning the control located near the handle (B) DWG.13
raise the load.
5. Turning the control located near the handle (B) DWG.13
lower the load.
6. After lifting the load, it is absolutely essential to rest it on appropriate support stands before performing any work
beneath it.
Remember! The jack is a lifting device and not a support device!
Remember! The jack is a lifting device and not a support device!
- The operator`s employer shall provide the necessary training and supply all information required to allow the operator to
use the jack safely.
- In the event that the distributor should fail during use, shut off the air flow directly by closing the safety cock located
between the air intake quick coupling and the distributor itself. DWG. 14
- When the jack is not in use, always keep the pistons or lifting arm lowered.
- Before working with the jack, it is advisable to perform a few operations with no load in order to acquire the sensitivity
- Before working with the jack, it is advisable to perform a few operations with no load in order to acquire the sensitivity
necessary to work safely with the jack.
necessary to work safely with the jack.
IMPROPER USE
IMPROPER USE
The air-hydraulic jack has been designed and manufactured to lift transport vehicles only. Any other use of the jack, such
as for instance lifting and/or moving persons, is considered to be completely improper. Any other use of the jack which
does not conform to the safety standards outlined in this manual shall be considered improper use and relieve the
manufacturer of any liability for damage or injury.
W W ARRANTY
ARRANTY
This jack is covered by a 12-month warranty starting from the date the jack leaves our factory unless the warranty has
been activated on-line; this covers all manufacturing defects but not transport expenses, defects caused by improper use
or damage suffered during transport. For more details please see the warranty card attached to this manual.
MAINTENANCE OPERA
MAINTENANCE OPERATIONS T
- To ensure your jack a long life it is advisable to clean the pistons externally once a fortnight.
- Check the level of oil in the tank at least twice a year.
(A) DWG.13 is located to the left of the operator; moving it upwards frees the
(B) DWG.13 to the right from the operator`s point of view makes the jack
(B) DWG.13 to the left from the operator`s point of view makes the jack
DWG. 14
TIONS TO BE PERFORMED BY THE USER
O BE PERFORMED BY THE USER
15
Publicité
