Bosch ErgoMixx MS6 Série Mode D'emploi page 14

en Troubleshooting
Troubleshooting
In the following table you will find solutions for problems or faults which you can easily
rectify yourself. If a fault cannot be eliminated, please contact customer service.
Problem
No vacuum can be
generated in the
storage container.
No vacuum can be
generated in the
zipper bag
The vacuum in the
zipper bag is not
maintained.
14
Possible cause
Lid is not fitted
properly / completely.
The lid gasket is not
inserted correctly.
Lid or sealing
elements are soiled
or damaged.
Zip lock is not
completely closed.
Zip lock or vacuum
seal is soiled or
damaged.
The zipper bag is
defective.
Holes may be made
in zipper bags by
sharp objects in the
food to be vacuum-
sealed (e.g. bones).
Remedy
■ Check the clips. Close them correctly.
■ Position the lid gasket properly.
■ Check lid, vacuum seal and lid gasket for
damage.
■ Check that all parts are clean and dry, in
particular the sealing elements.
■ Clean them thoroughly and leave
to dry in the air. X "Cleaning and
maintenance" see page 12
■ Close the zip lock tightly along the entire
length.
■ Check that sealing elements are clean.
■ Clean them thoroughly and leave
to dry in the air. X "Cleaning and
maintenance" see page 12
■ Check the zipper bag for damage.
If damaged use another zipper bag.
X "Accessories" see page 13
■ If damage has been caused by sharp
edges on the food to be vacuum-sealed,
position them in the zipper bag so they
cannot damage the walls of the bag.