Einhell Royal SPU 11 Instructions De Service page 3

Anleitung SPU 11 13.11.2001 14:14 Uhr
Area of use
The SPU 11 indoor fountain pump is desi-
gned for indoor use only, e.g. in planters,
indoor fountains, etc.
Technical data
Power supply
Output
Delivery rate max.
Delivery height max.
H (m)
0,50
0,25
0 50 100
Pump design
The centrifugal pump stator is hermetically
sealed in casting resin inside a plastic
housing. It is equipped with a 3 metre long
non-removable power cable plus earthing -
pin plug. During operation the permanent
magnet rotor runs in the water and requires
no lubrication.
Seite 3
230V ~ 50Hz
4 W
220 l/h
0.5 m
Q (L/h)
150 200 250
Special points to note
G To avoid damage to the bearings, never
allow the pump to run dry.
G
Only ever operate the pump from a proper
230V ~ 50Hz AC socket-outlet with
earthing contact and earth-leakage
circuit-breaker (30mA or 10mA).
G It is prohibited to use the pump outdoors,
e.g. in garden fountains or ponds. For
outdoor use the pump must be fitted with
a special 10 metre long HO7RN-F power
cable.
G
If the rate or height of delivery drops, clean
the intake housing (10) as follows:
G
Open the intake housing (10) by swivelling
downward.
G Clean the intake housing.
G When finished, re-assemble the intake
housing.
Particularly if the pump is used with hard
water (high calcium content), you should
clean all its rotating parts at regular intervals.
To do so, remove the intake housing, push
the filter wheel cover (8) to the rear and take
out the rotor. Clean each single part and re-
assemble in reverse order.
Ordering replacement parts
If you ever need to order replacement parts,
please quote the following data:
1. Machine type
2. Article No. of the machine
3. Ident. No. of the machine
4. Replacement part number of the item
required
GB
3