Ryobi BGH6110SB Manuel D'utilisation page 8

PRODUCT SPECIFICATIONS
Wheel Diameter ............................................................ 6 in.
Wheel Thickness .......................................................3/4 in.
Arbor Hole .................................................................1/2 in.
KNOW YOUR BENCH GRINDER
See Figure 2, page 11.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
GRINDING WHEELS
Equipped with coarse and fine grinding wheels to suit most
applications.
UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the Loose Parts
are included.
WARNING:
Do not use this product if any parts on the Loose Parts
List are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
FEATURES
No Load Speed .....................................3,600 r/min. (RPM)
Input ...................................................120 V~, 2.1 A, 60 Hz
ON/OFF SWITCH
The bench grinder features a front access On/Off switch for
convenience and safety.
SPARK SHIELDS AND SPARK DEFLECTOR
The spark shields and spark deflector are provided to ensure
your safety.
WORK REST
Provides a stable work surface when performing most
grinding tasks.
ASSEMBLY
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
WARNING:
Always spin the wheel by hand before turning on the
grinder to make sure the spark deflector doesn't hit the
grinding wheel.
MOUNTING GRINDER TO WORKBENCH
See Figure 5, page 12.
The bench grinder must be mounted to a firm supporting
surface such as a workbench or leg stand. Four bolt holes
have been provided in the tool's base for this purpose. Each
of the four mounting holes should be bolted securely using
machine bolts, lock washers, and hex nuts (not included).
Bolts should be of sufficient length to accommodate the
saw base, lock washers, hex nuts, and the thickness of the
workbench. Tighten all four bolts securely.
8 — English