Bosch TWK3P Serie Mode D'emploi page 10

en
Congratulations on purchasing this
Bosch appliance. You have acquired a
high-quality product that will bring you
a lot of enjoyment.
Parts and operating
controls
1 Kettle (with water level indicator)
2 Lid with lock
3 Lid release button
4 ON/OFF O switch, illuminated
5 Limescale filter (removable)
6 Base
7 Cable tidy
Important: Use the kettle only with its
included base.
■ Only fill the kettle with water. Milk
and instant beverages will burn and
damage the appliance. Never operate
the kettle without water and do not overfill
it; observe the min and max markings.
If the kettle is too full, the water will boil
over!
Before using for the first
time
■ Remove any stickers or film.
■ Unroll the right amount of cable from the
cable tidy and plug it in.
■ Fill the kettle with water. Bring the water
to a boil and discard it. Repeat the
procedure. This will make sure that the
kettle is clean for normal use.
■ When the water comes to a boil for the
first time, add a tablespoon of white
vinegar.
Boiling water
■ Fill the kettle with fresh water through the
spout or the open lid (press lid release
button).
■ Read the quantity on the water level
indicator. Do not fill with less than
0.25 litres or more than 1.7 litres of water!
■ Close the lid until it locks and place the
kettle on the base.
8
TWK3P_EU_8001244167.indb 8 TWK3P_EU_8001244167.indb 8
■ Press down the ON/OFF O switch; the
switch lights up. The water is heated.
■ The kettle switches off automatically once
the water has boiled.
The appliance can also be switched off
at any time by pulling up the ON/OFF O
switch.
Warning: If you remove the kettle from
the base and replace it before the heating
process is over, the kettle will not continue
to heat the water.
N.B.:
■ Only operate the kettle with the lid closed
and the limescale filter inserted, otherwise
the kettle will not switch off.
■ For physical reasons, the base may
collect some condensation water. This is
normal; it does not mean that the kettle
leaks.
■ After boiling, let the kettle cool down for
5 minutes before refilling it with water.
Warning: If the kettle is empty when
switching the appliance on, the overheat
control will switch it off automatically.
Cleaning and maintenance
W Danger of electric shock!
Never immerse the device in water or place
it in the dishwasher!
Do not steam-clean the appliance.
■ Before cleaning, unplug the appliance
from the power outlet.
■ Clean the outside of the kettle and base
with a damp cloth. Do not use strong or
abrasive cleaning agents.
■ Remove the limescale filter, soak it in a
little vinegar, then rinse clean with clear
water.
■ Rinse the kettle and the limescale filter
with clear water.
29.10.2021 12:14:19 29.10.2021 12:14:19