Publicité
Les langues disponibles
Les langues disponibles
en-us
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
¡ CAN/CSA C22.2 No. 61 - Household Cooking Ranges
¡ CSA C22.2 No. 64 - Household Cooking and Liquid-
Heating Appliances
¡ UL 1026 - Electric Household Cooking and Food
Serving Appliances
¡ UL 923 - Microwave Cooking Appliances
¡ UL 858 - Household Electric Ranges
¡ UL 507 - Electric Fans
¡ CAN/CSA C22.2 No. 113 - Fans and Ventilators
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.
1.6 Electrical safety
¡ Installer - show the owner the location of the circuit
breaker or fuse. Mark it for easy reference.
¡ If required by the National Electrical Code (or Canadian
Electrical Code), this appliance must be installed on a
separate branch circuit.
¡ Local codes vary. The installer is responsible for
ensuring that the installation, connections, and
grounding comply with all applicable codes. The
manufacturer is not responsible for improper installation
or the failure to follow appropriate local codes and
regulations.
¡ Be sure your appliance is properly installed and
grounded by a qualified technician. Installation,
electrical connections and grounding must comply with
all applicable codes.
¡ Refer to the rating plate for more information.
→ "Rating plate location", Page 15
WARNING
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
▶
ON accidentally.
The appliance must be disconnected from the source of
supply before attempting the installation.
For appliances equipped with a cord and plug, do not cut
or remove the ground prong.
▶
It must be plugged into a matching grounding type
receptacle to avoid electrical shock.
If there is any doubt as to whether the wall receptacle is
▶
properly grounded, the customer should have it
checked by a qualified electrician.
Before you plug in an electrical cord or turn on power
supply, make sure all controls are in the OFF position.
4
1.7 GROUNDING INSTRUCTIONS
This appliance must be grounded. Grounding reduces the
risk of electric shock by providing a safe pathway for
electric current in the event of a short circuit.
This appliance must be grounded. Connect only to
properly grounded outlet.
→ "Electrical installation - GROUNDING
INSTRUCTIONS", Page 9
WARNING
IMPROPER GROUNDING CAN RESULT IN A RISK OF
ELECTRIC SHOCK
Consult a qualified electrician if the grounding
▶
instructions are not completely understood, or if doubt
exists as to whether the appliance is properly
grounded.
DO NOT USE AN EXTENSION CORD.
▶
If the power supply cord is too short, have a qualified
▶
electrician install an outlet near the appliance.
This appliance is equipped with a cord having a grounding
wire with a grounding plug. The plug must be plugged into
an outlet that is properly installed and grounded.
1.8 Microwave safety
PRECAUTIONS TO BE OBSERVED BEFORE AND
DURING SERVICING TO AVOID POSSIBLE EXPOSURE
TO EXCESSIVE MICROWAVE ENERGY
¡ Do not operate or allow the appliance to be operated
with the door open.
¡ Make the following safety checks on all appliances to
be serviced before activating the magnetron or other
microwave source, and make repairs as necessary:
– Interlock operation
– Proper door closing
– Seal and sealing surfaces (arcing, wear, and other
damage)
– Damage to or loosening of hinges and latches
– Evidence of dropping or abuse
¡ Before turning on microwave power for any service test
or inspection within the microwave generating
compartments, check the magnetron, wave guide or
transmission line, and cavity for proper alignment,
integrity, and connection.
Publicité
