Fuchs design QUICK-FIX Notice De Montage page 10

7
8
9
10
11
12
7. Then apply glue to a short profile - as outlined
above.
8. Vertically stick the profile onto the side of the
glass brick and make sure that you meet the
existing long profile below to avoid sticking up into
where the next long profile needs to sit.
9. Apply more adhesive to the short profile stuck to
the glass brick.
10. Carry on until you have reached the desired
length of your wall.
11. Once the first row has been installed, check the
alignment. You can adjust as necessary if the glue
hasn't dried yet.
12. Now apply adhesive to the centre of the smooth
side of a long profile. Place this profile upside down
on the already installed row of bricks. Press on the
profile a little to make sure the glue will properly
stick onto the row of bricks below.
- 10 -