Publicité
Les langues disponibles
Les langues disponibles
Kick-back causes the saw to behave uncontrollably
and thus brings with a slack or blunt chain.
A poorly sharpened chain increases the risk of kick-
back. Never saw above shoulder height.
OPERATION - TIPS ON CHAIN SAW
USE
Sawing blocks
_
If possible, always use a saw horse.
_
Always start a cut with the chain running
and the serrated fender against the wood.
_
Rotate the serrated fender against the
wood to complete a cut.
The way of sawing depends on the way the
block is being supported.
Full-length support (the block is on the
ground):
_
Make a vertical cut downwards.
_
Make sure that you do not touch the ground.
Support at both ends (the block is on the
saw horse):
_
Make a vertical cut downwards to one
third of the longitudinal section.
_
Rotate the block and lay it on the saw
horse with the cut pointing downwards.
_
Make a second cut towards the first cut.
Support at one end (the block is on the saw
horse):
_
Make a vertical cut downwards.
Sawing trees
_
Make a horizontal cut to one third of the
diameter of the trunk. Subsequently make
a diagonal cut at a 45° angle from top to
bottom so that a notch is created.
_
Make a cut on the other side, but make
sure that you do not saw through the notch.
_
Place a wedge in the cut to make an
opening and drop the tree.
Felling trees is dangerous and
requires practice. If you are a
beginner or inexperienced, do not
try to teach yourself but seek
professional training.
CLEANING AND MAINTENANCE
Always pull the plug out of the
power socket before doing any
Keep the cooling vents on the motor housing
clean and unobstructed at all times.
Only the maintenance work described in these
operating instructions may be carried out. Any other
maintenance work must be carried out by our
Customer Service.
Do not modify the power saw in any way as this
could jeopardize its safety.
Should the chainsaw fail despite our careful
manufacturing and inspection procedures, have it
repaired by an authorized Customer Service work-
shop.
TECHNICAL DATA
Mains voltage V
Mains frequency Hz
Power input W
-1
Motor Speed min
No load speed m/sec
Bar length
OREGON
cutting length
Chain OREGON brake time ms
Oil container capacity ml
Weight kg
Protection class
Acoustic pressure level
L
Acoustic power level
L
Garantee : L
112 dB(A)
WA
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
Weighted root mean square acceleration according
to relevant standard.
Main Handle:
8.393 m / s ²
Auxiliary handle: 6.002 m / s ²
K = 1.5 m / s ².
37
work on the chainsaw!
230-240
50
2000W
n
: 7000
0
12.1
460mm
390mm
< 0.12 sec
280ml
5kg
IP20
85.9 dB(A)
K = 3 dB(A)
PA
105,9 dB(A) K = 3 dB(A)
WA
ATTENTION !
must be worn.
Publicité
