Lister 1600-4 Mode D'emploi page 19

Lister GmbH
Kalver Straße 24
58515 Lüdenscheid
Allemagne
MALFUNCTION
Motor does not run
Push in
Have the electronics replaced Motor runs very slowly
Recharge battery
Have the motor replaced
Have the motor replaced
CAUSE
Battery is empty
Contacts are dirty
Akku ist defekt
Replace battery
Have it repaired by service
centre
Resolve blocking
Have it repaired by service
centre
Overload protection always
trips
Free the blockage
Have the motor replaced
Have the motor replaced.
Have the electronics repla-
ced.
Reduce the shearing tension.
Have the blade sharpened.
Motor part becomes warm
Do not tighten pressure tensi-
on nut so much.
If the blades still do not cut,
they should be resharpened
or
replaced
Motor vibrates
Motor has a very loud noise
Page 19
RECTIFICATION
Recharge battery
Turn off the clipper. Clean the
terminals and the battery
Battery defective
Burning smell from the motor
housing/motor burned
Blocked shaving head
Motor and / or electronics
defective
Overload protection tripped
out
Knife blocked
Motor defective
Overload protection defective
Motor defective
Electronics defective
Shearing tension too high
Battery is almost empty
Shearing tension too high
clipping
Motor bearing defective
Motor defective
Motor defective
EN