Publicité
Les langues disponibles
Les langues disponibles
4. Operation
4.1 Safety
CAUTION
This heated underblanket is equipped with a SAFETY SYSTEM. This sensor technology prevents the
entire surface of the heated underblanket from overheating by automatically switching off the heated
underblanket in the event of a fault.
If the safety system has switched off the heated underblanket, the temperature setting is not illuminated
any more even when the heated underblanket is switched on.
Please note that the heated underblanket is not operable any more due to safety reasons in this case
and has to be sent to the service address indicated.
4.2 Putting into operation
This electric underblanket must be affixed between the mattress
and the bed sheet.
1. Leave space for the pillow and place the electric underblanket
on the mattress with the plug-in connector facing the pillow.
The plug-in connector is located on the underside of the electric
underblanket.
2. Run band "A" under the mattress to loop "B". Thread the band
through loop "B" and then run it under the mattress to loop "C".
Tightly attach the band to loop "C".
3. Run the middle band "D" under the mattress to loop "E" and
tightly attach it there.
4. Run band "F" under the mattress to loop "G". Thread the band
through loop "G" and then run it under the mattress to loop "H". Tightly attach the band to loop "H".
NOTE:
Do not bind the electric underblanket too tightly to the mattress.
CAUTION
Regularly check the position of the electric underblanket on the mattress.
The electric underblanket must never be used if it is folded.
After you have affixed the electric underblanket to the mattress, simply put the bed sheet on top as usual so
that the electric underblanket is between the mattress and the bed sheet.
CAUTION
Make sure that the heated underblanket is spread out entirely flat and that it will not rumple up or
crease when in use.
• To operate the heated underblanket connect the controll to the heated underblanket by plugging in the
connector.
• Then plug in the supply plug into the mains outlet.
4.3 Switching on
To switch on the heated underblanket, set the slider for ON/OFF and temperature settings to setting 1, 2 or 3.
The temperature settings are illuminated when switched on.
H
12
C
E
B
G
D
F
A
Publicité
