Spengler AUTOTENSIO Manuel Utilisateur page 29

AC Adapter jack is on the right side of the monitor. Medical AC adapter(DC 6.0 V,600mA) can be used with the
device (recommended, not provided). The adapter connect pin should be positive inside and negative outside
with a 2.1mm coaxial joint.
Do not use another type of AC adapter as it may harm the unit.
EN
AC Adapter Jack
System Settings
With power off, press " " button about 3 seconds to actuate system setting, The Memory Group icon flashes.
1. Select memory Group
While in the System Setting mode you may accumulate test results into 2 different groups.
Press "M" button to choose a group setting.
The test results will automatically store in each selected group.
2. Time /Date Setting
Press " " button again to set the Time/Date mode. Set the month first by adjusting the "M " button. Press " "
button again to confirm current month. Continue setting the day, hour and minute in the same way. Every time
the " " button is pressed, it will lock in your selection and continue in succession (month, day, hour, minute.)
Applying the Arm Cuff
1. Firmly insert air plug into opening located on left side of monitor unit.
29