emerio CBC-124348.2 Mode D'emploi page 9

12 + or –
13
OK
14 TEMP
15 + or –
16 OK
17 TIME ON
18 + or –
19 OK
20 TIME OFF
21 + or –
22 OK
Timer setting is finished. The current temperature will appear on the LED display after approx. 10 seconds.
If you want to set the second timer, please repeat the steps above.
Attention (1):
The timer settings which you make under "01" (executed only once) should be made for the current week. On
Sunday (day 7) at 24:00, all "01" settings will be set to "non-activated". Therefore, a timer setting for Saturday
that you made on Tuesday will work, but a timer setting for Tuesday that you make on Saturday will not work!
Attention (2):
If a timer setting with number 01 was made for this day, you must manually set the next timer setting for this
day to 02 using the button "+". Otherwise, the timer setting 01 will be overwritten.
Attention (3):
Start & stop times can only be set in whole hours (not in minutes).
Note:

If the appliance is switched off by using the power switch or by removing the plug from the electrical
outlet, the day will be set to 01 and the time will count from 00 (hour) and 00 (minute) for the next time
you switch the appliance on again. However, the timers that were set previously are still stored. Therefore,
to avoid misunderstandings, the weekly timer function will be automatically set to OFF ("OF" shown in LED
display) in case of turning the heater off using the power switch or removing the plug from the socket.
Otherwise, the heater would switch on and off at the wrong times. Make sure to reset the current day and
time once turn on the appliance again and remember to set the weekly timer function to ON ("ON" shown
in the LED display) as described in above table.

During the timer setting, if no button is pressed for approx. 10 seconds, the timer setting will stop and you
will have to start all over again.

All timer settings – maximum 28 settings: seven (7) days multiplied by maximum four (4) settings per day –
are processed consecutively. Therefore, make sure that they do NOT contain contradictions.
01 to 04 flashes
The selected number
HP
00 to 37 flashes
The selected
temperature
HE
00 to 23 flashes
The selected start time
HF
"start time +1" to 24
flashes
The selected stop time
You can make totally 4 timers per day. So name the timer with
a number (01, 02, 03 or 04) to distinguish from each other.
[See Attention (2)].
Set the desired temperature (0 - 37 °C). The default setting
Set the desired start time from 00 to 23. [See Attention
Set the desired stop time from the "start time +1" to 24.
For example, if the start time is 10, the stop time can only
be set from 11 to 24. [See Attention (3)].
- 8 -
is 20 °C.
(3)].