Publicité
Les langues disponibles
Les langues disponibles
REMOVING THE GREASE FILTER
Switch off the electricity! Remove the plug from the socket.
Open the bottom part of the cooker hood by pulling it carefully downwards.
Pull the grease filter towards you and tilt it downwards at the front. Make sure you guide the grease filter with you other hand to
prevent the grease filter from falling down on your cooking appliance.
REPLACING THE CARBON FILTERS
A carbon filter cleans the air and filters the smell that occurs during cooking. A carbon filter can not be
washed and reused. In all cases it is necessary to replace the carbon filter at least every four months.
• Open the cooker hood.
• Remove the grease filters.
• Attach the carbon filters to the grease filters.
• Replace the grease filter and close the cooker hood.
REPLACING THE LED LIGHTING
This appliance is equipped with a LED light. It can be used for a long time. In case, the LED light is blown, it must be replaced by a
qualified person to avoid any hazard. Contact the Inventum service department.
6
troubleshooting
What to do in case of a malfunction? In most cases, you will be able to correct these faults easily yourself. Please check the solutions
below before contacting the Inventum service department.
The motor is not running
• Is it plugged in correctly?
• Is there a power outage?
• Check the electrical installation.
The performance of the cooker hood is not correct and makes more nois.
• Is the diameter of the exhaust-air pipe correct?
• Is the duct blocked?
• The diameter of the duct must be 150 mm. A smaller diameter can negatively influence the suction of the motor.
• Are the grease filters clean?
• Are the carbon filters not replaced within the last 6 months? Replace the carbon filters.
• Is there enough air supply to replace the extracted air?
19
English
•
Publicité
