Programming; Enter Programming Mode; Program A Transmitter In Modes 1, 2 Or - Bosch LE10 Manuel D'utilisation

LE10 Radio Receiver
5

Programming

5.1

Enter programming mode

To enter programming mode, press simply button T1 for the
desired time. See Section 4.1 Connecting ports, page 35.
NOTICE!
Both relays will not be activated in the programming mode.
5.2

Program a transmitter in modes 1, 2 or 5

NOTICE!
Per programming sequence only one transmitter can be
matched. You can program up to 20 transmitters.
To start programming
–
Device behavior
–
–
Within these 30 seconds, activate the transmitter that you want
to match, the following behavior should be observed:
–
This indication confirms that the transmitter is programmed.
–
–
You can repeat the sequence with another transmitter.
Bosch Security Systems
Press button T1 for min. 1 second and max. 3 seconds.
LED 1 stays permanently green.
LED 2 blinks red slowly for maximum 30 seconds.
LED 1 and LED 2 blink alternating green-red for 6 seconds.
If the transmitter is already programmed, then LED 2
blinks fast for 6 seconds after activating the transmitter.
If 20 transmitters are already programmed, then LED 2
blinks fast for 10 seconds directly after activating the
button T1 between 1 and 3 seconds.
User Manual
Programming | en
F.01U.139.675 | V1 | 2009.10
37