Connecting The Power Supply; Power Supply With The Rj12 Power Socket; Power Supply Connected To A Wired Installation - Bosch LE10 Manuel D'utilisation

34 en | Installation
3.3

Connecting the power supply

There are two different ways to connect the power supply of
the LE10 Radio Receiver. After connection, the LE10 Radio
Receiver will be in standby mode.
3.3.1

Power supply with the RJ12 power socket

The LE10 Radio Receiver can be powered by a power supply
unit (PSU). The PSU should be plugged in the RJ12 socket on
the rear side of the unit and should be easily accessible at any
time. See Section 4.1 Connecting ports, page 35 for access to
the socket. See Section 8 Technical data, page 46 for
information about the power supply.
3.3.2

Power supply connected to a wired installation

The LE10 Radio Receiver can be powered by connecting a wired
input into poles 1 and 2 of the connection board. See
Section 4.1 Connecting ports, page 35 for information about the
power supply.
F.01U.139.675 | V1 | 2009.10 User Manual
LE10 Radio Receiver
Bosch Security Systems